How to Plug In Behind a Couch, Bed or TV Stand Without the Gap

Flat plug extension cord hiding behind the couch — white Maximm 360° plug in the wall outlet beside a dark grey couch

You push the couch back, and it stops short of the wall. There's a gap, the cord is bent hard behind the plug, and the second outlet is covered.

That's the plug, not the furniture. A regular plug is 1.1 inch thick, sticks straight out, and points one way.

The 2 problems

  • Furniture won't go back flush.
  • The cord bends hard and gets squashed between the furniture and the wall.

The fix


The Maximm 360° flat plug extension cord behind furniture is only 0.6 inch thick and sits flat against the wall, so the couch, bed, or TV stand goes right back, flush, with no gap.

And it turns a full 360°, so you point the cord down or to the side — no forced bend, and the outlet below stays open. 

Maximm 360° 1-outlet flat rotating plug extension cord

Pick yours in 10 seconds

Shop the 360 that fits behind furniture

Get the 1-outlet 360 for behind the couch or bed

Get the 3-outlet 360 for behind the TV

Shop all Maximm 360° Rotating Extension cords

Will it fit?

A regular plug needs about 1.1 inch. The Maximm 360° plug needs only 0.6 inch.

Plug it in, turn it so the cord runs down or to the side, with no hard bend. Turn it aside and the outlet below stays open for another plug. Then push the furniture back gently — close to the wall, never pressing on the cord.

Maximm 360° cords are UL Listed, in 16 AWG and 14 AWG.

The bottom line

The plug was the problem, not the furniture. A flat plug extension cord behind furniture that turns 360° is what lets your couch, bed, and TV stand go right back — flush, with no gap, and no bent cord.




Back to blog

Leave a comment